06.) Connect All Four

Materials Needed: Stacked Plastic Sheets #1-#4, Measuring Tape, Scissors, Marker, Gorilla Tape

Move to the door side (top) – Start taping sheets #2 & #3 together:

• Fold sheet #4 back for now.
• Line up the edges of Sheet #3 & Sheet #2 
• Fold the tape over from Sheet #3 and attach to Sheet #2.
• Tape the entire length.
• Smooth out the air bubbles as much as possible.

Move down taped Sheets #3 & #2 a tad to reveal Sheet #1:

• Fold back sheet #4 and tape to sheet #1
• Line up edges and fold the tape over from sheet#4 and attach to Sheet #1.
• Smooth out the air bubbles as much as possible.

Move to the fan side (bottom) – Start taping Sheets #4 & #3 together:

• Line up the edges of Sheet #4 & Sheet #3.
• Fold the tape over from Sheet #3 onto #4 and tape the entire length.
• Smooth out the air bubbles as much as possible.

Once you’ve taped these together – Do the same for Sheets #2 & #1.

• Line up edges of Sheet #2 and fold the tape over and attach to Sheet #1.
• Tape the entire length.
• Smooth out the air bubbles as much as possible.

Take Sheet #4 and fold the FAN side edge up towards the DOOR side edge revealing Sheet #2 

• You are looking to manipulate Sheets #3 and #1 leaving Sheet #2 on top of the stacked pile and Sheet #4 on the bottom.

Pull up the center (taped edge) between Sheets #2 & #3.

Fold Sheet #3 in on itself with the edges of Sheet #2 & #4 meet.

Do the same for Sheet #1.

• Fold Sheet #1 in on itself with the edges of Sheet #2 & #4 meet on the fan side.
• Smooth out the middle folds